HOT AIR BLOCK OFF PLATES

[Al Zim]

We have been producing block off plate kits for our customers who want the rear pan on the engine to remain flat. The kit comes with two plates (unpainted), block-offs for the lower air channels and hardware 'similar' to what the factory used.
call us for more details 800.356.2964

[David Nicholls]

Dear Al
A much needed product.
Could you post a picture ?
All the Best
David

[Peter Schueren]

Al, where can I find those kits in your catalogue?????
I tried but failed,
Peter

[Dave Hegeman]

Matt Howard at Deluxe Customs has these block off plates and caps available. I made my own plates but used the caps on my car. They're nicely made and finished and fit well.

No affiliation here, just a happy customer.

https://shop.deluxecustoms.com/product- ... 107-00.htm
https://shop.deluxecustoms.com/product- ... 107-01.htm

Dave H.

[Sean O'Donnell]

I think this is the product. https://store.allzim.com/356-912-heat-r ... ck-off-set

[Peter Schueren]

you are right... but a friend of mine made them for me and they do the job.

[Wes Bender]

The plates are half of the equation. The cups should also be used.

[Martin Benade]

Not that much is happening here with open flapper boxes.

[Wes Bender]

When winter sets in, you'll want the hot air that is escaping through the former carb heat outlets to help heat the cabin. Leaving the outlets under the plates uncapped kind of defeats the purpose. I would cap them, even down here in the desert southwest (if I were to remove the carb heat horns).

[Harlan Halsey]

+1