Hi All
On the Earlier Engines (616/2) etc The Centre Main Bearing is located by a small Dowel Pin , instead of the later tabs
and sometimes the centre bearing housing takes a pounding.and this Dowel Pin elongates the location hole. What is the 'Fix' for this problem ? Weld and re drill ? or go up a size dowel pin?
Regards Jay
Centre Main Bearing
-
John Clarke
- 356 Fan
- Posts: 2115
- Joined: Wed Aug 27, 2008 6:38 am
- Location: East Sussex, England
- Contact:
-
Jacques Lefriant
- 356 Fan
- Posts: 4656
- Joined: Mon Dec 06, 2010 1:50 pm
- Location: Washoe county NV
Re: Centre Main Bearing
Hi Jay
usually, a stepped dowel will suffice if the line bore is correct (which was the probable cause of the working of the pin).
j
usually, a stepped dowel will suffice if the line bore is correct (which was the probable cause of the working of the pin).
j