Re: WCSTA -09- Coupe into Speedster conversion
Posted: Sat Jun 19, 2021 6:02 pm
Part 2
new rear tail section rough fitments as well. Quarter panels in with the tail section next to go. Tail skin final reassembled and tacked in. Most this section was cut back apart and reset to contour and flow correctly with the quarters. The lower apron was also to low and had to be raised. A lot of adjustments to get this all to fit. Rear end complete and moving onto the front. Nose was installed and set off of the adjusted and latched hood first then the fenders where installed.
Just like the rear it didn't just fall into place; a ton of nip and tucking required to get it all to fit and flow properly. Just shy of 2,200 hours later we had viable Speedster bodied coupe chassis. This final post hit all the high spots but there was a ton of work and effort that into this car between these photos. If you'd like to see more details on all that went into building this car you can find the rest of this story here: https://forum.abcgt.com/forum/main-foru ... conversion
Thanks for looking!
Justin
Top frame mounts with rear cowl installed. Continuing the body line off of the cowl with an original open car decklid. Fortunately I had an original Speedster shell as continual reference as I went.
Engine compartment closing panels mostly installed and now rough fitting the new quarter panels.new rear tail section rough fitments as well. Quarter panels in with the tail section next to go. Tail skin final reassembled and tacked in. Most this section was cut back apart and reset to contour and flow correctly with the quarters. The lower apron was also to low and had to be raised. A lot of adjustments to get this all to fit. Rear end complete and moving onto the front. Nose was installed and set off of the adjusted and latched hood first then the fenders where installed.
Just like the rear it didn't just fall into place; a ton of nip and tucking required to get it all to fit and flow properly. Just shy of 2,200 hours later we had viable Speedster bodied coupe chassis. This final post hit all the high spots but there was a ton of work and effort that into this car between these photos. If you'd like to see more details on all that went into building this car you can find the rest of this story here: https://forum.abcgt.com/forum/main-foru ... conversion
Thanks for looking!
Justin