Thanks
Mark
- thumbnail.jpg (93.81 KiB) Viewed 1097 times
throttle linkage?
-
Mark Scharnikow
- 356 Fan
- Posts: 35
- Joined: Mon Oct 27, 2008 2:03 pm
-
Martin Benade
- 356 Fan
- Posts: 12390
- Joined: Wed Nov 23, 2011 10:52 am
- Location: Cleveland, Ohio
Re: throttle linkage?
I can’t Identify it exactly but it is throttle cross shaft for an older car with two single throat Solex carbs. The 32 and 40 mm sizes took different versions of your part.
Unlike the later cars it moves from side to side to open the throttles.
Unlike the later cars it moves from side to side to open the throttles.
Cleveland Ohio
62 Cabriolet
56 VW
02 IS 300
04 Sienna
62 Cabriolet
56 VW
02 IS 300
04 Sienna
-
Vic Skirmants
- Registry Hall of Fame
- Posts: 9303
- Joined: Tue Oct 27, 2009 5:02 pm
- Location: SE Michigan
- Contact:
Re: throttle linkage?
Probably for a Super.
-
Alan Hall
- 356 Fan
- Posts: 1462
- Joined: Wed Mar 26, 2008 12:06 pm
- Location: Orinda, CA
Re: throttle linkage?
This doesn't look like a factory 356 part, maybe homemade or for other than stock carbs.
Photo shows 2-pc case Normal top and 2-pc case Super and 3-pc case Normal and Super bottom.
Photo shows 2-pc case Normal top and 2-pc case Super and 3-pc case Normal and Super bottom.
- Attachments
-
- DSCN9978.JPG (384.69 KiB) Viewed 1074 times
-
Tony Proasi
- Classifieds Moderator
- Posts: 327
- Joined: Thu Mar 27, 2008 12:40 pm
- Location: Louisville KY
- Contact:
Re: throttle linkage?
It’s possibly for a VW and bent so it can go up and over or under the fresh air heat ducts on the fan shroud.