The first batch of belts for 2 piece engines are done! These are the correct size for 2 piece engine cases only. I also make belts for 3 piece engines, and they are different.
Also, please look further down in this thread to see the second type of Pre-A belts I make for the 2 piece case. Yes, 2 kinds for the 2 piece case and one more for the 3 piece case Pre-A's
Looks like this first batch is sold out, but I will do some more. Contact me off line to order/ questions/ etc.
$89 each and with PayPal and shipping within the USA, it comes to $99 delivered.
Minimum order for outside USA is 2 belts.
Pre A Generator Belts
- Paul Hatfield
- 356 Registry Member
- Posts: 1149
- Joined: Tue Mar 25, 2008 5:46 pm
- Location: Washington State
- Contact:
Pre A Generator Belts
- Attachments
-
- IMG_2209.jpg (232.17 KiB) Viewed 2625 times
Last edited by Paul Hatfield on Thu Sep 05, 2019 7:04 pm, edited 1 time in total.
Paul Hatfield
"Miss April"
http://www.enginesinback.com
"Miss April"
http://www.enginesinback.com
- Paul Hatfield
- 356 Registry Member
- Posts: 1149
- Joined: Tue Mar 25, 2008 5:46 pm
- Location: Washington State
- Contact:
Re: Pre A Generator Belts
Completed a run of the second type of Pre-A belts. These are also 13 x 850 and correct for 2 piece engines. Three piece Pre-A take a different size belt which I also can supply, but they are different than shown below.
So, here you go- smooth belt, not cogged, and vintage artwork hand applied.
So, here you go- smooth belt, not cogged, and vintage artwork hand applied.
- Attachments
-
- Pre-A Final (5).JPG (144.47 KiB) Viewed 2625 times
Paul Hatfield
"Miss April"
http://www.enginesinback.com
"Miss April"
http://www.enginesinback.com