Thanks Martin - will check that outMartin Benade wrote: ↑Tue Sep 27, 2022 11:03 pm And the pushrod hole is tapered enough to allow the angled pushrod enough freedom of movement?
Bent Pushrod from Brake Pedal to M/C
- Ken Tuvman
- 356 Fan
- Posts: 867
- Joined: Sun Mar 17, 2019 10:22 pm
- Location: Lake Minnetonka MN
Re: Bent Pushrod from Brake Pedal to M/C
Author / Photojournalist
- Ken Tuvman
- 356 Fan
- Posts: 867
- Joined: Sun Mar 17, 2019 10:22 pm
- Location: Lake Minnetonka MN
Re: Bent Pushrod from Brake Pedal to M/C
Okay - figured out what the problem is - had car at son's shop tonight - we replaced the clutch cable and Bowden tube - much better action now! The accelerator pedal didn't have a spring behind it but it does now and much nicer feel.
Figured out the sticking brake pedal > there was a previous repair to the front end collision damage - somebody did some not so precise welding in bulkhead area - the master cylinder is not sitting straight and level - it's definitely out of alignment - so we're going to address that as soon as I can grab my son again.
Thank You everyone for your suggestions.
Figured out the sticking brake pedal > there was a previous repair to the front end collision damage - somebody did some not so precise welding in bulkhead area - the master cylinder is not sitting straight and level - it's definitely out of alignment - so we're going to address that as soon as I can grab my son again.
Thank You everyone for your suggestions.
Author / Photojournalist
- Phil Planck
- 356 Fan
- Posts: 2034
- Joined: Wed Mar 26, 2008 7:21 pm
- Location: NE Michigan, lower penn.
- Ken Tuvman
- 356 Fan
- Posts: 867
- Joined: Sun Mar 17, 2019 10:22 pm
- Location: Lake Minnetonka MN
Re: Bent Pushrod from Brake Pedal to M/C
Back at it this afternoon and after receiving a pep talk from Martin B. - Not quite there but making progress by tightening down master cylinder nuts with a 13mm curved wrench - The brake pedal is returning with the bent brake pushrod so next session will try with the new pushrod that is straight. Getting exciting here . . .
Last edited by Ken Tuvman on Fri Sep 30, 2022 6:55 am, edited 1 time in total.
Author / Photojournalist
- Greg Scallon
- 356 Fan
- Posts: 787
- Joined: Thu Mar 27, 2008 1:12 pm
- Location: Los Altos, CA
Re: Bent Pushrod from Brake Pedal to M/C
Hey Ken, I guess you know now how the pushrod got bent. .
Good sleuthing. Glad you're on track to getting it all fixed up.
-Greg
Good sleuthing. Glad you're on track to getting it all fixed up.
-Greg
'58 Speedster
'56 VW Deluxe Microbus
'56 VW Deluxe Microbus