CAD Drawing Needed!

[Eric McKinley]

Good to hear from you Vic, it's been a while.

Its good to see your protective nature coming out once again, nice shot about the 4th July, but I wasn't around then, so don't blame me on that

[Sebastian Gaeta]

You think he might be a little busy, so can't find the time to answer you immediately?
We Yanks have been celebrating our own BREXIT here around July 4.

Hi Vic,

Spot on as usual. Just got back from Nashville visiting my daughters and did not go online much. As for Eric, I've had to interact with him before and am not at all surprised by the snarky tone.

As for the CAD drawing, keep in mind that the actual CAD file is not mine to give away since Bob Watts is the one who created it. It is my design but not my file so I guess I would need his permission to pass it on to anyone else.

[Vic Skirmants]

"snarky tone."
Yeah, that's been my experience too.

[Eric McKinley]

Fellas, you both know why we had words, I am not the type to mention anything on the forum, or lower myself to name calling.

There appears to be only 2 people I have had a run in on the forum and its not unusual both have a common ground and come to each other's side for support. Enough said, you got your open forum guys lets leave it at that.

[Vic Skirmants]

[Bob Watts]

It is not my project to give away so I did not answer.
As far as the dxf file, it would be fine with me. But that is up to Sebastian.

[Sebastian Gaeta]

It is not my project to give away so I did not answer.
As far as the dxf file, it would be fine with me. But that is up to Sebastian.

Thanks Bob. I'll be happy to forward it to anyone who wants it but perhaps they may want to wait to see how mine turn out and of I encountered any issues.