C tool kits/bags. I'll show you mine, you show me yours
- Tom McCoy
- 356 Fan
- Posts: 196
- Joined: Wed May 14, 2008 12:27 pm
- Location: Atlanta Georgia
Re: C tool kits/bags. I'll show you mine, you show me yours
Last set of pictures
Registry Number: Who cares?
- Tom McCoy
- 356 Fan
- Posts: 196
- Joined: Wed May 14, 2008 12:27 pm
- Location: Atlanta Georgia
Re: C tool kits/bags. I'll show you mine, you show me yours
Paul Hatfield wrote:Very impressive. Especially for a McCoy!
No feud here!
~Paul Hatfield
HA!!
Dont turn your back at the next Concours, you might be missing a fan belt!!
Registry Number: Who cares?
- George Bryan
- Registry Hall of Fame
- Posts: 583
- Joined: Tue Mar 25, 2008 5:38 pm
- Location: Evans, GA
Re: C tool kits/bags. I'll show you mine, you show me yours
That makes two, four wrench bags with the maroon leather pouch for the red/maroon bakelite Messko....hmmm, wonder if the 'absolutely correct' gray pouch tale around the campfire is burning a little lower now?
Regards,
George
Regards,
George
- Charlie White
- 356 Fan
- Posts: 3143
- Joined: Fri Mar 14, 2008 1:12 pm
Re: C tool kits/bags. I'll show you mine, you show me yours
Got my Bynocks out this morning to watch some quail nesting in my hedge, and noticed the clasp on the case looked exactly like the toolbag clasps we have been seeing on "C" toolkits. So if you need a clasp, and can't find one, get a Bushnell Bynocks case!
CW
CW
Charlie White
- Tom McCoy
- 356 Fan
- Posts: 196
- Joined: Wed May 14, 2008 12:27 pm
- Location: Atlanta Georgia
Re: C tool kits/bags. I'll show you mine, you show me yours
Did you cook them yet?Charlie White wrote:to watch some quail nesting in my hedge CW
- Charlie White
- 356 Fan
- Posts: 3143
- Joined: Fri Mar 14, 2008 1:12 pm
Re: C tool kits/bags. I'll show you mine, you show me yours
Bump! C'mon guys, let's see some more "C" toolkits!
CW
CW
Charlie White
- George Bryan
- Registry Hall of Fame
- Posts: 583
- Joined: Tue Mar 25, 2008 5:38 pm
- Location: Evans, GA
Re: C tool kits/bags. I'll show you mine, you show me yours
EASY Jim, get any good pics from North South to add to this thread? Looks like out of all the C/SC cars out there, only a few of us must have tool kits, since no other pics are showing up.
Regards,
George
Regards,
George
- Jim Breazeale
- Classifieds Monitor
- Posts: 2804
- Joined: Thu Mar 27, 2008 8:07 pm
- Tag: SF Giants Fan
- Location: SF Bay Area
- Contact:
Re: C tool kits/bags. I'll show you mine, you show me yours
GeorgeGeorge Bryan wrote:EASY Jim, get any good pics from North South to add to this thread? Looks like out of all the C/SC cars out there, only a few of us must have tool kits, since no other pics are showing up.
Regards,
George
Most, if not all, of the C owners parked their cars and left to look at other cars. I did the same thing. I wish C owners would come forward and post pictures of their tool kits. Again, there is no right or wrong and nobody will get flamed for posting pictures.
Regards
Jim Breazeale
www.easypor.com
www.facebook.com/pages/European-Auto-Salvage-Yard-EASY/120458108029410
www.easypor.com
www.facebook.com/pages/European-Auto-Salvage-Yard-EASY/120458108029410
- Ned Hamlin
- 356 Fan
- Posts: 343
- Joined: Wed Apr 09, 2008 12:18 pm
- Location: Sun Valley, ID
Re: C tool kits/bags. I'll show you mine, you show me yours
OK Jim, here is the tool kit that came with my '64 C coupe. It includes a screwdriver I bought from Harvey Rosenthal, a knock of a 10 - 11 wrench since mine was cut in half, presumably to remove carb nuts, a new Pudenze fuse pack, and a tire gauge I found on Ebay. Notice, though, the original Phoenix fan belt, dated, 02/4.
- Attachments
-
- phplpv4xaPM.jpg (20.26 KiB) Viewed 5782 times
Ned Hamlin
'64 Bali Blue coupe
'65 Togo Brown SC
'58 Ruby Speedster
'65 Dolphin Grey coupe
'63 Carrera 2 coupe
If you don't know where you're going, any road will take you there - George Harrison/Yogi Berra
'64 Bali Blue coupe
'65 Togo Brown SC
'58 Ruby Speedster
'65 Dolphin Grey coupe
'63 Carrera 2 coupe
If you don't know where you're going, any road will take you there - George Harrison/Yogi Berra
- Jim Breazeale
- Classifieds Monitor
- Posts: 2804
- Joined: Thu Mar 27, 2008 8:07 pm
- Tag: SF Giants Fan
- Location: SF Bay Area
- Contact:
Re: C tool kits/bags. I'll show you mine, you show me yours
Ned
Thank you for your contribution. Now, lets see some more.
Regards
Jim Breazeale
www.easypor.com
www.facebook.com/pages/European-Auto-Salvage-Yard-EASY/120458108029410
www.easypor.com
www.facebook.com/pages/European-Auto-Salvage-Yard-EASY/120458108029410
- Bill Waite
- 356 Fan
- Posts: 297
- Joined: Tue Mar 25, 2008 6:05 pm
- Location: Grand Rapids, Michigan
Re: C tool kits/bags. I'll show you mine, you show me yours
Pics below are of the tool pouch original to our '65 356C Karmann coupe (221004 - late '64 production) after it was cleaned up and "restored". I don't have the before cleanup pictures, but it looked pretty much like Dan Schaefer's as posted on page one of this thread. However, the chrome clips were not very rusted on ours and they polished up pretty well.
Cleaned the exterior (black) ribbed vinyl and applied some 303 Aerospace Protectant. It is actually a darker black than the photos seem to show.
The inside "light off white / gray" colored vinyl was dirty and stained, but it cleaned up well with the careful application of some lacquer thinner. I then used SEM brand "ColorCoat" vinyl coating (#17033 "Light Parchment"). Color was near perfect match to the original. I still have a bit of stitching repair to do.
Missing about 1/3 the tools, so will be looking for the balance as time and $$ permit.
Regards,
Bill
Cleaned the exterior (black) ribbed vinyl and applied some 303 Aerospace Protectant. It is actually a darker black than the photos seem to show.
The inside "light off white / gray" colored vinyl was dirty and stained, but it cleaned up well with the careful application of some lacquer thinner. I then used SEM brand "ColorCoat" vinyl coating (#17033 "Light Parchment"). Color was near perfect match to the original. I still have a bit of stitching repair to do.
Missing about 1/3 the tools, so will be looking for the balance as time and $$ permit.
Regards,
Bill
Last edited by Bill Waite on Fri Aug 05, 2011 8:56 am, edited 1 time in total.
Bill Waite
Grand Rapids, MI
1965 356C Coupe "Reversible Outlaw"
Grand Rapids, MI
1965 356C Coupe "Reversible Outlaw"
- Adam Wright
- Classifieds Monitor
- Posts: 10322
- Joined: Wed Mar 12, 2008 1:00 am
- Tag: KTF
Re: C tool kits/bags. I'll show you mine, you show me yours
I always thought the white insides didn't come out until the introduction of the 912 kits. This could be a game-changer.
www.unobtanium-inc.com
Check out my Barn Find column in the Registry magazine, always looking for good stories.
Check out my Barn Find column in the Registry magazine, always looking for good stories.
- Bill Waite
- 356 Fan
- Posts: 297
- Joined: Tue Mar 25, 2008 6:05 pm
- Location: Grand Rapids, Michigan
Re: C tool kits/bags. I'll show you mine, you show me yours
Adam,
I think our '65 coupe (221004) is among the last 500 C's produced. The inside isn't really "white" so much as a very light gray or "dirty white" color. Dan Shaefer's '64C tool bag on page one of the thread is the same color (the inside of his would probably clean up much like mine did prior to re-coloring with the vinyl/fabric coating). It also looks like the black vinyl on his is the same texture as ours: very fine straight "ribs" (definitely not the faux leather look or smooth like some that have been pictured).
Anyone else out there with a late 356C that has the same color combination?
Bill
I think our '65 coupe (221004) is among the last 500 C's produced. The inside isn't really "white" so much as a very light gray or "dirty white" color. Dan Shaefer's '64C tool bag on page one of the thread is the same color (the inside of his would probably clean up much like mine did prior to re-coloring with the vinyl/fabric coating). It also looks like the black vinyl on his is the same texture as ours: very fine straight "ribs" (definitely not the faux leather look or smooth like some that have been pictured).
Anyone else out there with a late 356C that has the same color combination?
Bill
Bill Waite
Grand Rapids, MI
1965 356C Coupe "Reversible Outlaw"
Grand Rapids, MI
1965 356C Coupe "Reversible Outlaw"
-
- 356 Fan
- Posts: 1064
- Joined: Tue Apr 19, 2011 1:40 pm
Re: C tool kits/bags.
I'll show you mine, you show me yours.. That was my favorite game as a kid . Then soon after that. The other classic, just the tip!!!! now that was a good game.. i guess there is some advantages on growing up on a street of all girls.
- Tom McCoy
- 356 Fan
- Posts: 196
- Joined: Wed May 14, 2008 12:27 pm
- Location: Atlanta Georgia
Re: C tool kits/bags. I'll show you mine, you show me yours
Judging from the lack of responses, these tool kits are far more valuable than I thought.
Tom
Atlanta
Tom
Atlanta