Page 1 of 1

MS Paint?

Posted: Tue Nov 07, 2017 7:58 pm
by Ron LaDow
Really off-topic:
Is anyone here familiar with MS Paint? I can get it to color-fill at some times and not at others.

Re: MS Paint?

Posted: Wed Nov 08, 2017 10:58 pm
by Alan Hall
Ron,
I'll bite, is MS a brand, or a MS mil-spec, or a type of paint?
Alan

Re: MS Paint?

Posted: Wed Nov 08, 2017 11:23 pm
by Sebastian Gaeta
Alan,

MS = Microsoft. MS Paint is a basic graphics manipulator.

Ron,

If this is just for an isolated project I can help you with it if you'd like. I use Adobe Photoshop and InDesign. If it's a general MS Paint question then I am not familiar with using it and cannot help, sorry.

Re: MS Paint?

Posted: Thu Nov 09, 2017 12:19 am
by Alan Hall
Sebastian,
Thanks...I feel a little silly for not recognizing that Ron was talking a software item!

Re: MS Paint?

Posted: Thu Nov 09, 2017 2:31 am
by Ron LaDow
Alan,
My mistake; I should have been more clear, but I was FRUSTRATED! But thank you for at least looking at the post in the hopes of helping.
Sebastian,
Thank you for your attempt to help also, and perhaps I might end up helping you.
Suffice to say that PAINT works for at least 90% of the drawings Pre Mat sends to vendors, but cross-hatching to indicate sections is a pain and 'filling' with some color would be wonderful if it would do the same. Except:
Here's what I've found after doing (as you can imagine) some serious A-B reduction head beating (change this, still work?; step two, change that, [iterate until the answer is obvious]....)
If you open a PAINT document and begin creating forms, it works exactly like the tutorials on YouTube: Click on the 'fill' bucket, choose a color, click on the space and viola!.
However, if you start with a document created in some other format and then open it in PAINT, the "fill" function simply does not work. And the Pre Mat sketch sheet is generated in Photo Viewer; tough.
But here's where I might return the favor:
If you are ever in need of doing so, look up there a bit to the left on the PAINT tool bar and you'll see a listing of "brushes". It is much, much quicker to use those with the color of your choice to define a section view than to try to free-hand cross-hatches across a large diameter tube, for example.
Again, thanks to both of you.

Re: MS Paint?

Posted: Thu Nov 09, 2017 8:48 am
by Vic Skirmants
Alan Hall wrote:Sebastian,
Thanks...I feel a little silly for not recognizing that Ron was talking a software item!
Me too. I was wondering if he was brushing it on or using a spray gun?

Re: MS Paint?

Posted: Thu Nov 09, 2017 8:57 am
by Neil Bardsley
Vic Skirmants wrote:
Alan Hall wrote:Sebastian,
Thanks...I feel a little silly for not recognizing that Ron was talking a software item!
Me too. I was wondering if he was brushing it on or using a spray gun?
Both are available on MS Paint :)