The Official 356Talk Forum

I'm checking the route of this and have searched the previous posts but I'm not sure of the answer. I know it goes out the front bulkhead, with a clamp holding it up onto the 'fuel tank shelf'. Does it then go through the hole under the steering box inspection hatch, along the torsion bars and out the other side and then through another hole before going into the grommet in the axle? Hopefully the photos will help, I have marker on one of the holes with a pull through showing through, the last hole, before it goes into the axle, is seen about 8 o'clock position on the 1st photo, below the brake line you can see pushed through the steering arm tunnel

Thanks,

V