'55 Speedo cable route

For Pre A discussions and questions
Post Reply
Message
Author
Vincent Gillespie
356 Fan
Posts: 246
Joined: Sun Jul 18, 2010 8:33 am
Location: United Kingdom
Contact:

'55 Speedo cable route

#1 Post by Vincent Gillespie » Fri Aug 31, 2018 11:42 am

I'm checking the route of this and have searched the previous posts but I'm not sure of the answer. I know it goes out the front bulkhead, with a clamp holding it up onto the 'fuel tank shelf'. Does it then go through the hole under the steering box inspection hatch, along the torsion bars and out the other side and then through another hole before going into the grommet in the axle? Hopefully the photos will help, I have marker on one of the holes with a pull through showing through, the last hole, before it goes into the axle, is seen about 8 o'clock position on the 1st photo, below the brake line you can see pushed through the steering arm tunnel

Thanks,

V
Attachments
SPEEDO CABLE ROUTE 005.JPG
SPEEDO CABLE ROUTE 006.JPG
V. Gillespie

Post Reply