Pre A 2pc. Engine X2

Message

Joe Ruiz · #1 Post by **Joe Ruiz** » Wed Feb 28, 2018 3:28 am

Putting together a couple of Pre A 1500cc engines this week.

Joe Ruiz · #2 Post by **Joe Ruiz** » Thu Apr 19, 2018 11:58 am

Pistons / Cyls. are installed. Now pre fitting the sheetmetal, exhaust, fuel lines and installing oil sump.

Martin Bruechle · #3 Post by **Martin Bruechle** » Thu Apr 19, 2018 2:01 pm

Very nice Joe. 2 thumbs up.

Alan Hall · #4 Post by **Alan Hall** » Thu Apr 19, 2018 8:51 pm

Which piston and cylinders are you using Joe?

Mike TEMPELS · #5 Post by **Mike TEMPELS** » Sat Apr 21, 2018 1:13 pm

Hello joe , can you provide some circular oil sumps, like this mounted on your engine ?
Regards

Mike

Joe Ruiz · #6 Post by **Joe Ruiz** » Sat Apr 21, 2018 1:18 pm

Alan Hall wrote:Which piston and cylinders are you using Joe?

Hi Alan.

I'm using the Shasta Dura Bar iron cylinders and JE pistons/rings/pins/locks.

Joe Ruiz · #7 Post by **Joe Ruiz** » Sat Apr 21, 2018 1:19 pm

Mike TEMPELS wrote:Hello joe , can you provide some circular oil sumps, like this mounted on your engine ?
Regards

Mike

Unfortunately, I only have 'em for my engine restorations.

Mike TEMPELS · #8 Post by **Mike TEMPELS** » Thu Apr 26, 2018 2:21 am

Joe , you do so a perfect work !
But send an engine from Europe to USA and back to have your awesome oil sump is too much for so a little guy like me .

Mike

Pre A 2pc. Engine X2

Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2

Re: Pre A 2pc. Engine X2