Hello, can the 'Oracles' confirm that the pull knob for the engine lid comes through the little hole in the upholstery panel pointed to with the pencil in the attached photo?
Thanks
V
Engine lid pull knob on a '55
-
- 356 Fan
- Posts: 440
- Joined: Sun Jul 18, 2010 8:33 am
- Location: United Kingdom
- James Davies
- 356Talk Moderator
- Posts: 2959
- Joined: Thu Aug 15, 2013 9:15 am
- Location: Heidelberg, DE
Re: Engine lid pull knob on a '55
Yes! Make sure the rod in which the cable slides does not stick out the hole though.
-
- 356 Fan
- Posts: 440
- Joined: Sun Jul 18, 2010 8:33 am
- Location: United Kingdom
Re: Engine lid pull knob on a '55
Thanks for the photo and information which will be of great use.
This was already taken apart when I got the car, I was pretty sure I was correct but with your, and many others, knowledge available to check I thought it best to ask what may seem a silly question.
Our guiding rule is if it was original we will try and put it back but who would think vinyl could shrink and distort so much. To manipulate the original vinyl on the door cards I worked in our kitchen in front of the fan oven going at full blast with the door open, plus a hot air blower also on full on a very hot day, but it was still a battle. Unfortunately I can't get the car in the kitchen to do the same so this could get interesting.
V
This was already taken apart when I got the car, I was pretty sure I was correct but with your, and many others, knowledge available to check I thought it best to ask what may seem a silly question.
Our guiding rule is if it was original we will try and put it back but who would think vinyl could shrink and distort so much. To manipulate the original vinyl on the door cards I worked in our kitchen in front of the fan oven going at full blast with the door open, plus a hot air blower also on full on a very hot day, but it was still a battle. Unfortunately I can't get the car in the kitchen to do the same so this could get interesting.
V
V. Gillespie
- James Davies
- 356Talk Moderator
- Posts: 2959
- Joined: Thu Aug 15, 2013 9:15 am
- Location: Heidelberg, DE
Re: Engine lid pull knob on a '55
Cool Vincent! I think it's fantastic you're reusing the original vinyl, patching where needed. Is the original interior on yours this beige vinyl with cord inserts on the front and rear seats?
It's interesting that it's a bit lighter shade than the other beige vinyl I've seen used during this period. That vinyl has little brown speckles on it, which gives it a bit darker shade overall.
It's interesting that it's a bit lighter shade than the other beige vinyl I've seen used during this period. That vinyl has little brown speckles on it, which gives it a bit darker shade overall.
-
- 356 Fan
- Posts: 440
- Joined: Sun Jul 18, 2010 8:33 am
- Location: United Kingdom
Re: Engine lid pull knob on a '55
Hello James, The vinyl interior is actually grey, the picture was taken inside so the colour doesn't come out very well, if you look at a post I made about cleaning the seats the photo is taken outside in sunlight so the colour in the photo is good. I have made a frame to try & stretch the panels, we'll see if this is possible as they have shrunk 30+mm top to bottom, front to back is only about 10mm, probably something to do with the weave of the natural fabric supporting the man made stuff of the material.
V
V
V. Gillespie