Porsche356registry.org
http://forum.porsche356registry.org/

Steel heater tubes for PRE-A and A cars
http://forum.porsche356registry.org/viewtopic.php?f=19&t=45328
Page 1 of 1

Author:  Mike DeJonge [ Wed Jan 10, 2018 11:19 am ]
Post subject:  Steel heater tubes for PRE-A and A cars

Correct steel tubing for PRE-A and A cars. In stock, ready to ship!!

Attachments:
IMG_4749.jpg
IMG_4749.jpg [ 1.09 MiB | Viewed 731 times ]
IMG_4748.jpg
IMG_4748.jpg [ 1.84 MiB | Viewed 731 times ]

Author:  Mike DeJonge [ Wed Jan 10, 2018 12:40 pm ]
Post subject:  Re: Steel heater tubes for PRE-A and A cars

this is the steel flexible tubing from the heater can to the heat exchanger on the engine.
paper tubing is not correct/concourse

Author:  Mike Wilson [ Sun Jan 14, 2018 10:51 pm ]
Post subject:  Re: Steel heater tubes for PRE-A and A cars

Mike: THANKS!

Is one long enough for both sides or do you need two?

Mike

Author:  Herlin E. Woolery [ Thu Jan 18, 2018 10:45 pm ]
Post subject:  Re: Steel heater tubes for PRE-A and A cars

Is this for T1 only or can be used on T2
Herlin
58 A coupe

Author:  Mike DeJonge [ Fri Jan 19, 2018 10:20 am ]
Post subject:  Re: Steel heater tubes for PRE-A and A cars

One tube per side. If doing both sides, you will need to order 2.
Good for T2 cars as well 1950-59

Author:  Mike Wilson [ Sun Jan 21, 2018 6:51 pm ]
Post subject:  Re: Steel heater tubes for PRE-A and A cars

Thanks, Mike. They look great!

Mike

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/