356 Front End Lift & Support Beam

Vendor announcements of new 356 products, product changes, recalls, requests for product feedback, or changes to their business.
Post Reply
Message
Author
User avatar
Albert Tiedemann
356 Fan
Posts: 1229
Joined: Thu Apr 03, 2008 2:46 pm

356 Front End Lift & Support Beam

#1 Post by Albert Tiedemann »

A prototype of the subject beam was shown at the Hershey Swap, 2014. Some improvements were reflected in the initial run [some shown at the Hershey Swap in 2015] and others outside the meet to clients requiring custom interfacing with floor jacks on hand/already in use. Since that time, a variation of the design has been developed to include a model for the 912 and early 911. A final evolution of design has produced a unit that may be used for either 356 or 912/911 application Aside from the standard interface, all "models" can be special ordered to accommodate nearly all floor jack interfaces likely in use at a modest additional cost. Each of the 3 models will be on display at the Ski Roundtop 13th Annual Vintage Swap Meet on September 19, 2015.
Albert Tiedemann, C356C
"The Hermit"

Post Reply