new Pre A front floor pans

[Mike DeJonge]

New Tooling developed from an original, confirmed and documented 1952 pre A floor pan. correct dimensions of all depressions, including the wider central depression under the center tunnel, and the small rib at the front of the tunnel and different dimensions for the small pad under the tunnel, and the different size pads for where the seat mount is welded. The triangle at the sides of the floor pan are different and have sharper corners. Also the long rib from side to side is longer
Pre A front floor pans are NOT the same as A floor pans. Rear floor pans to follow.
We now also have front A floor pan dies and they are being polished and we should have correct stampings next week.
these are our own production, galvaneal sheet metal so there is superior rust protection.
check out the pictures

[Ruben Bastida Martinez]

Do you have the rear floor pans available as well?

[Mike DeJonge]

pre A rear floor pans should be done in 6-8 weeks hopefully

[Ruben Bastida Martinez]

pre A rear floor pans should be done in 6-8 weeks hopefully

Hi again Mike, are the rear pans available now?

thanks!
rubén

[Mike DeJonge]

rear pre A floor pans are being machined right now. Polishing of the die than has to take place. We should have the rear pans in stock aprox 2-3 weeks from now

[Mike DeJonge]

Rear pre A floor pans are now available. copied from a certified 1952 car