Page 1 of 10
Type A Outlaw Project
Posted: Sun Oct 07, 2018 8:52 am
by Perry DePietro
As I have posted a couple of times in other threads, I started this project 20 years ago. I found a '56 sunroof coupe sitting in dirt/bottom half of the car completely rusted away. I cut to top off (still in surprisingly good condition) and grafted it onto a '57 shell. I sold the car around 2001 and recently re-purchased it. I have made some progress the last couple of months and will try to post some photos as I go.
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 8:56 am
by Perry DePietro
I have a lot more photos to upload, but I am getting an error message saying that the file size (even for one photo) is too large. Is there an easy fix to file size issue?
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:31 am
by Perry DePietro
Wide 5 front, drop link install
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:33 am
by Perry DePietro
GT mirror install
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:35 am
by Perry DePietro
Willwood hydraulic pedal assembly
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:39 am
by Perry DePietro
Rear Wide 5 disc brakes
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:42 am
by Perry DePietro
Sway bar install
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:46 am
by Perry DePietro
Vic Skirmants camber regulator (thanks Vic for the help with the install). ...and my shop buddy, Hank.
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:50 am
by Perry DePietro
Boyd Coddington Wheels. They are truly beautiful. (Thanks Chris).
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:54 am
by Perry DePietro
Gas filler handle fabrication
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 9:57 am
by Perry DePietro
Floors replaced
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 10:01 am
by Perry DePietro
Other metal replacement
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 10:11 am
by Perry DePietro
more pix
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 10:14 am
by Perry DePietro
hydraulic clutch slave cylinder install
Re: Type A Outlaw Project
Posted: Sun Oct 07, 2018 10:21 am
by Perry DePietro
Filled in trim holes and bumper bracket holes. Decided to lower the mounting position of the license plate (built in LED light in the upper frame).