Need some advice for my 912 motor in the 356 Coupe

For those who couldn't care less how their 356 left the factory!
Message
Author
Edwin Ek
356 Fan
Posts: 1812
Joined: Sat Jun 21, 2008 11:16 am
Location: Santa Monica, CA

Re: Need some advice for my 912 motor in the 356 Coupe

#16 Post by Edwin Ek » Fri Jun 01, 2018 12:58 am

What you are calling the flywheel (with the part number stamped) is actually the pressure plate.
#6386

User avatar
Phil Planck
356 Fan
Posts: 1469
Joined: Wed Mar 26, 2008 7:21 pm
Location: NE Michigan, lower penn.

Re: Need some advice for my 912 motor in the 356 Coupe

#17 Post by Phil Planck » Fri Jun 01, 2018 8:52 am

Chris

IMO, yes, that is what you need for a flywheel machined for a 180mm clutch. If you have a latter 200mm flywheel, then need the 200 kit.
Phil Planck

Post Reply