The Official 356Talk Forum

I am finishing the interior of my 356 c coupe (1964).
Would like to know the exact places for the fasteners, is there a drawing or photo available?

Thanks inadvance

Do you have the original floor boards? If so, you can line up the fasteners on the mat with the ones on the boards. If not, I'm sure someone will post pics.

Mike

I checked, but the wooden floorboards were replaced by new ones.
Now looking for th exact or correct place to install the fasteners

Picture of drivers side floor board with it's 2 snaps in this link. No dimensions though: viewtopic.php?f=1&t=39840&p=247867&hili ... at#p247867

Dear Doug

Thank you for your help. Have to check how the passanger side is fastened.
Do you know (or have) a very original car type C (from 1964-5)?

I also have reproduction floor boards and a new mat without snaps.

Photos of our original 356C toe boards before & after restoration. If you need exact measurements, let me know.

Thanks Bill. I knew you would come through.

Thanks this will help! May be for future refernce it is possible to have exact measurements, I am sure this question will pop up in the future.

Measurements to centers of snap fittings from toe board edges. In good old fashioned inches...