Page 1 of 1

rear tail lights B coupe

Posted: Fri Jun 01, 2018 7:33 pm
by Helge Tielker
Guys, unfortunately I have bought 2 right side rear tail lights. So I am looking for a left one (left means drivers side). But I also want to know more about the different types being available. As well that I want to know the measurement/ sizes of the original bolts.

Image - Image

this is the type where I got 2 x right ones of .... together with the counter frame .... do I need a washer between the nut and the inner frame?
Any tip is appreciated.

Re: rear tail lights B coupe

Posted: Fri Jun 01, 2018 10:58 pm
by Mike Wilson
The B parts manual shows 6 "distance washers" used with the backing plate. They look like flat washers.

Mike

Re: rear tail lights B coupe

Posted: Sat Jun 02, 2018 2:13 am
by Helge Tielker
Thanks for the reaction,

and do you know the measurements by chance of the washers?

Here a pic of two different types tail lights I have (found this pic on the internet):

Image

I have a third type where you can remove the holder of the big bulb by pressuring on kind of spring.

Image

Does anyone knows originality and combines year and how to see whether it is a after market one?

Re: rear tail lights B coupe

Posted: Sat Jun 02, 2018 9:45 am
by Edwin Ek
Notice that the originals have bullet connectors. The more recent ones have screw terminals.

Re: rear tail lights B coupe

Posted: Sat Jun 02, 2018 11:33 pm
by Mike Wilson
Unfortunately no size is listed for the washer. I'll try to Google the part number to see if I can find it. Ed is correct about the wiring connections. For some reason, the repros have a screw terminal rather than a bullet connection. You can make a pigtail wire using a female bullet connection on one end and a tinned bare wire on the other to connect to the tail light. That way you don't have to cut off the male bullet connector.

Mike

Re: rear tail lights B coupe

Posted: Sat Jun 02, 2018 11:47 pm
by Mike Wilson
No luck on the size. Googling the part number shows a couple of sites that list the part as unavailable and describes it as a spacer. Perhaps someone with an original car and or part can weigh in.

Mike

Re: rear tail lights B coupe

Posted: Sun Jun 03, 2018 2:46 pm
by Glen Hamner, Jr
Its a washer! Take one like you need to your local parts store (hardware store, HomeDepo, Lowes) and bring back something close enough, galvanized is better. Or, make some authenticity seller's day and purchase an original piece of Porsche steel. Maybe these washer-shims were made in the USA, or some country closer at hand. Better yet, make your local Porsche parts department's day. Or, make your own washer with a small hole cutter, and, do use a piece of Porsche body metal for the benefits of a lighter chassis. To smooth out the body metal washer, mount it on your drill and turn it smooth with your bench belt sander. For corrosion protection, following the wire brush brightening of your newly fabricated washer, coat the authentic Porsche steel washer with cold zinc spray-on. Several coats, allowing to fully dry (between coats) before installation. Life is good in the slow lane. <;-)

Re: rear tail lights B coupe

Posted: Mon Jun 04, 2018 1:37 am
by Helge Tielker
Glen Hammer THUMB UP! ;)