Page 1 of 1
Gebi Bolts
Posted: Tue May 30, 2017 9:50 pm
by Michael Gregg
I can't find any reference to Gebi hardware on the forum. I've found a few so far used on my '64 356C as link pin pinch bolts and tie rod clamp bolts. I have found some references over on The Samba site. Anyone else seen these bolts on their 356?
Re: Gebi Bolts
Posted: Sun Jun 04, 2017 11:42 pm
by Brad Ripley
GEBI has been around since 1885 and still going -- see
http://bierbach-gmbh.de/englisch/company.php
Re: Gebi Bolts
Posted: Mon Jun 05, 2017 12:15 am
by Martin Benade
Has anyone else found their bolts on a 356? I have not heard of that brand myself.
Re: Gebi Bolts
Posted: Sat Jun 17, 2017 8:58 am
by Michael Gregg
I've also found some NEDUR 8G bolts used on the rear torsion bar bushing cover.
Re: Gebi Bolts
Posted: Mon Jun 19, 2017 12:30 am
by Brad Ripley
Company that once used trademark NEDUR is Koninklijke Nedschroef Holding B.V., in the Netherlands. See their website:
https://www.nedschroef.com/en/about_nedschroef/history/
Re: Gebi Bolts
Posted: Wed Jun 28, 2017 10:41 pm
by Jon Bunin
It's not a brand that I see often, especially on a 356.
I was searching through my photos for other reasons, and found this- a 935 transmission that I rebuilt recently...
Re: Gebi Bolts
Posted: Tue Jul 11, 2017 10:53 am
by Etienne Kerkhoffs
My windshield wiper mechanism (356 T2) has Gebi bolts:
Re: Gebi Bolts
Posted: Tue Jul 11, 2017 11:30 am
by Charles H Jacobus
Jon:
The quality of the wire raps on those safety wired bolts looks like you might have been an aircraft mechanic, nice!
ChuckJ
Re: Gebi Bolts
Posted: Wed Jul 12, 2017 2:50 am
by Jon Bunin
Thank you Chuck. I've worked on various things with wings, but nothing designed to leave the ground.
Re: Gebi Bolts
Posted: Thu Jul 13, 2017 11:04 am
by Wes Bender
+1 Jon. Safety wiring like that is a sign of attention to detail.