Rear seats installation
- Guido Kwikkers
- 356 Fan
- Posts: 82
- Joined: Tue Nov 08, 2011 5:00 pm
- Location: ex-Haarlem car, soon in Germany
Rear seats installation
I am about to install the rear seats. This part of ther estoration I have not dissambled so i am struggling a bit.
How should the folding rear seat be mounted?
What parts for installation are needed, I doubt I have them so I need to re-order most likely.
Moreover I see (in teh picture) places for other parts to be installed there as well, what should be done there?
Thanks in advance.
How should the folding rear seat be mounted?
What parts for installation are needed, I doubt I have them so I need to re-order most likely.
Moreover I see (in teh picture) places for other parts to be installed there as well, what should be done there?
Thanks in advance.
- Mike Wilson
- Classifieds Monitor
- Posts: 11636
- Joined: Tue Apr 15, 2008 4:37 pm
- Location: SW Los Angeles
Re: Rear seats installation
The middle or inboard attachments are on the posts in the middle. The outside attachments are with the two large headed chrome screws and wavy washers.
Mike Wilson
Lomita, CA
'63 B coupe
Lomita, CA
'63 B coupe
- Guido Kwikkers
- 356 Fan
- Posts: 82
- Joined: Tue Nov 08, 2011 5:00 pm
- Location: ex-Haarlem car, soon in Germany
Re: Rear seats installation
Ok thanks.
Can some one please upload a picture showing which parts are used here.
Or ideally pictures of work being done in restoration process as well ass finished car.
I am struggling to match PET/Stoddard cataglogue information with my car.
Thanks
Can some one please upload a picture showing which parts are used here.
Or ideally pictures of work being done in restoration process as well ass finished car.
I am struggling to match PET/Stoddard cataglogue information with my car.
Thanks
- Mike Wilson
- Classifieds Monitor
- Posts: 11636
- Joined: Tue Apr 15, 2008 4:37 pm
- Location: SW Los Angeles
Re: Rear seats installation
1 & 2: screw locations for chrome luggage strap loops.
3: rear window defroster
4, 5 & 6: screw locations for carpet that is on the back rests of the rear seats.
7 & 10: screw locations for sides of rear seat backs
8 & 9: pivot point for rear seat backs
3: rear window defroster
4, 5 & 6: screw locations for carpet that is on the back rests of the rear seats.
7 & 10: screw locations for sides of rear seat backs
8 & 9: pivot point for rear seat backs
Mike Wilson
Lomita, CA
'63 B coupe
Lomita, CA
'63 B coupe
- Stephen Masefield
- 356 Fan
- Posts: 354
- Joined: Sat Dec 25, 2010 2:32 pm
- Location: Zion National Park, Virgin Utah
Re: Rear seats installation
That fat insulation ?? on the demister tube may cause issues with the fitting of the rear and side panels - don't think you need it.
Also tape up /cover the downward facing demister holes- no need for air to go down - it all needs to head to rear glass.
Also tape up /cover the downward facing demister holes- no need for air to go down - it all needs to head to rear glass.
Steve
'57 Coupe
'61 Sunroof Coupe
'79 911SC Targa (Stupidly sold)
'23 Subaru BRZ (poor mans Porsche)
Ford Diesel to haul 'stuff'
'57 Coupe
'61 Sunroof Coupe
'79 911SC Targa (Stupidly sold)
'23 Subaru BRZ (poor mans Porsche)
Ford Diesel to haul 'stuff'
- Mike Wilson
- Classifieds Monitor
- Posts: 11636
- Joined: Tue Apr 15, 2008 4:37 pm
- Location: SW Los Angeles
Re: Rear seats installation
Stephen: I think the car is a C coupe so the insulation, I believe, is correct. As you know, the C models had the plastic vents rather than the defroster tube under the rear window.
Mike Wilson
Lomita, CA
'63 B coupe
Lomita, CA
'63 B coupe
- Guido Kwikkers
- 356 Fan
- Posts: 82
- Joined: Tue Nov 08, 2011 5:00 pm
- Location: ex-Haarlem car, soon in Germany
Re: Rear seats installation
Correct! The car is a C coupe from 1964.
I got informed that between the rear seats it should all be covered with isolation material. My interior specialist glued this part directly on to the metal without any isolation.
The vertical parts were covered with isolation.
Can someone check with their own restoration or experience and advice If I am doing it the correct (authentic) way?
I got informed that between the rear seats it should all be covered with isolation material. My interior specialist glued this part directly on to the metal without any isolation.
The vertical parts were covered with isolation.
Can someone check with their own restoration or experience and advice If I am doing it the correct (authentic) way?
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
The correct thickness of the jute padding on the rear firewall was 1/2 inch when I removed my original. I made a new one form 1/4 inch jute by glueing two layers together. If it is too thick or too thin it will make fitting your rear Garnish rails difficult. The hump between the rear seat bottoms originally had a "hat" if you will, of coconut fibers under the carpet.This coconut fiber was over the black tar paper insulation. I was unable to salvage mine so did a similar covering of dense closed cell foam. You could also make the "hat" from a material like dynamat. A little softer than the original stuff but smoothed out the hump when carpeted. Mike was of course "spot on" with his numbers labeling. Did your T6B have similar coconut fiber on the hump Mike?
Last edited by Doug McDonnell on Mon Nov 07, 2016 10:19 pm, edited 2 times in total.
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
Guido Is your car a Karmann or Reutter?
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
Also there is an order in which you must install the carpeting. I don't remember the exact steps look at photos and pay attention to where the binding is and you should be able to figure it out. If I remember correctly my carpet kit from Autos International had numbers on the back. I think volume 2 of Registry Restoration guide has an article .
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
Pic of foam covering hump
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
More pics from my install 65C coupe
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
-
- 356 Fan
- Posts: 221
- Joined: Thu Jan 15, 2009 4:01 pm
- Location: Sydney, AUSTRALIA
Re: Rear seats installation
Hi Guido, Sent you a few photos. Hope they help. jim
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear seats installation
Excellent carpet article in restoration Guide Volume 2 by Ron Roland. It was originally in Registry Magazine 19-1 here: https://porsche356registry.org/system/m ... 1396814795
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Helge Tielker
- 356 Fan
- Posts: 243
- Joined: Fri May 09, 2008 2:49 pm
- Location: The Netherlands/ Rotterdam area
- Instagram: www.instagram.com/helge356/
- Contact:
Re: Rear seats installation
Doug, I can not access this article either I can find it ... can someone help me on the issue .,.... I have so many questions with regard to the carpet installation ....Doug McDonnell wrote:Excellent carpet article in restoration Guide Volume 2 by Ron Roland. It was originally in Registry Magazine 19-1 here: https://porsche356registry.org/system/m ... 1396814795
Like: the material underneath how to fix it on the ground and than the carpet above? All glue?
cheers from Holland .. temperatures here happily rises to 19 celsius ...
Helge
356 B Coupe 12/59 ruby red/ black
"REDMAXX"
356 C Coupe 64 BaliBlue
(under restoration)
"REDMAXX"
356 C Coupe 64 BaliBlue
(under restoration)