Hi all,
Recently replaced pictured T2 rubber interior Matt with newer one. New one does not have the four or so small round chrome finished pieces in it. I want to install new ones into new Matt. I could eyeball the locations but would rather get some location measurements to get it right.
Any help is appreciated.
KTF,
Steve
Placement measurements needed on rubber floor matt T2.
- Steve Raucher
- 356 Fan
- Posts: 772
- Joined: Sat Jan 09, 2010 9:58 am
- Location: Seaside CA 93955
- Alan Hall
- 356 Fan
- Posts: 1462
- Joined: Wed Mar 26, 2008 12:06 pm
- Location: Orinda, CA
Re: Placement measurements needed on rubber floor matt T2.
Hi Steve,
I believe the pieces you are referring to are the rings that hold the female portion of the snaps. Location should match the male portion of the snaps on your floorboards.
I believe the pieces you are referring to are the rings that hold the female portion of the snaps. Location should match the male portion of the snaps on your floorboards.