Placement measurements needed on rubber floor matt T2.

For those who obsess about exactly how their 356 left the factory!
Post Reply
Message
Author
User avatar
Steve Raucher
356 Fan
Posts: 770
Joined: Sat Jan 09, 2010 9:58 am
Location: Seaside CA 93955

Placement measurements needed on rubber floor matt T2.

#1 Post by Steve Raucher »

Hi all,
Recently replaced pictured T2 rubber interior Matt with newer one. New one does not have the four or so small round chrome finished pieces in it. I want to install new ones into new Matt. I could eyeball the locations but would rather get some location measurements to get it right.
Any help is appreciated.
KTF,
Steve
Attachments
IMG_2121.JPG
 

User avatar
Alan Hall
356 Fan
Posts: 1453
Joined: Wed Mar 26, 2008 12:06 pm
Location: Orinda, CA

Re: Placement measurements needed on rubber floor matt T2.

#2 Post by Alan Hall »

Hi Steve,
I believe the pieces you are referring to are the rings that hold the female portion of the snaps. Location should match the male portion of the snaps on your floorboards.

Post Reply