Good Afternoon 356C Friends,
1964 356C Karmann Coupe
I need some help with how the two vertical sheet metal area under the outer center longitudinal between the front closure panels and the door hinge post get rebuilt. See the area that I am referring to in the left drivers side and right pass side that I have attached and circled in the photos. I still have a very small flat rusted horizontal edge of the sheet metal that might be the bottom closure and the answer to my question.
Do the two vertical sheetmetal panels get extended a few inches down to bottom of hinge and then closed off horizontally with a bottom narrow closure panel between the two vertical panels?
I was hoping that some one might have a photo of this area and how this area is repaired before I install the outer center longitudinal and the front closure panels.
Any description or photo will be much appreciated.
Thanks Frank Swanson
Tacoma, WA
Front Closure Panel Door Hinge Area Interior
- Frank Swanson
- 356 Fan
- Posts: 29
- Joined: Fri Jul 13, 2012 10:09 am
- Tag: 1964 356SC
- Location: Tacoma, WA
Front Closure Panel Door Hinge Area Interior
- Attachments
-
- Front Closure and Hinge Area.png (1.31 MiB) Viewed 457 times
- Phil Planck
- 356 Fan
- Posts: 2035
- Joined: Wed Mar 26, 2008 7:21 pm
- Location: NE Michigan, lower penn.
- ScottBerry
- 356 Fan
- Posts: 237
- Joined: Mon Aug 05, 2013 7:49 pm
- Location: Cobourg, Ontario
Re: Front Closure Panel Door Hinge Area Interior
Phil head on over to Justin’s site at abcgt. Lots of build threads with details of what you are after.
He is a link to some of the work I did in this area but other builds on this site show lots of examples.
https://www.abcgt.com/new-forum/forum/m ... sto/page18
Go to page five of the thread
He is a link to some of the work I did in this area but other builds on this site show lots of examples.
https://www.abcgt.com/new-forum/forum/m ... sto/page18
Go to page five of the thread
1960 356B (110196) restoration project in progress
1968 912 Restoration Complete
1968 912 Restoration Complete
- John Brooks
- 356 Fan
- Posts: 2173
- Joined: Tue Jul 08, 2008 11:50 am
- Location: Whidbey Island WA.
- Contact:
Re: Front Closure Panel Door Hinge Area Interior
this is a A but they are similar, there are several other A pillar forward photos on other rebuilds here
https://www.abcgt.com/new-forum/forum/m ... vertible-d
https://www.abcgt.com/new-forum/forum/m ... vertible-d
John Brooks
62 Roadster
66 912
84 Cab
getting pushed around in porsches since 1965
62 Roadster
66 912
84 Cab
getting pushed around in porsches since 1965