- Is the cap gasket dry fit?
- I have two gaskets left over from the rebuild kit with no obvious home. In theory they could go on the side screws or the top cap bolt? Where do they go?
- Is the patterned side (left) the "red coated face" mentioned in the workshop manual that contacts the valve seat (i.e. not the spring side)
Early Fuel Pump Reassembly
- Dennis Vogel
- 356 Fan
- Posts: 505
- Joined: Sat Oct 25, 2008 6:10 pm
- Location: Santa Rosa, CA
- Contact:
Early Fuel Pump Reassembly
I took on the satisfying task of rebuilding my early fuel pump today. It was mostly successful, but left me with a few questions:
1960 356 S90 Sunroof Coupe
1970 914-6
2014 Carrera S
1970 914-6
2014 Carrera S
-
- 356 Fan
- Posts: 4205
- Joined: Tue Mar 25, 2008 9:28 pm
Re: Early Fuel Pump Reassembly
Cover seal is installed dry.
Seals are for side plug and top cover bolt.
Rough side of valve phenolic piece goes against tiny spring
Seals are for side plug and top cover bolt.
Rough side of valve phenolic piece goes against tiny spring