Picture request - Rear floor corners in 64C
-
- 356 Fan
- Posts: 376
- Joined: Wed May 10, 2017 4:14 pm
Picture request - Rear floor corners in 64C
I'm fitting my new floors and I was hoping that somebody could post a picture or two of the two rear corners of their floor pan where the corners 'turn up' in between the side and rear flanges. Any help would be appreciated. I should have taken more detailed photos.
- Phil Planck
- 356 Fan
- Posts: 2032
- Joined: Wed Mar 26, 2008 7:21 pm
- Location: NE Michigan, lower penn.
-
- 356 Fan
- Posts: 376
- Joined: Wed May 10, 2017 4:14 pm
Re: Picture request - Rear floor corners in 64C
Thanks for that. Are the short diagonal corners sitting on a flange?
- Martin Benade
- 356 Fan
- Posts: 12345
- Joined: Wed Nov 23, 2011 10:52 am
- Location: Cleveland, Ohio
Re: Picture request - Rear floor corners in 64C
The entire perimeter is sitting on flanges. The central tunnel is above rather than under the floor.
Cleveland Ohio
62 Cabriolet
56 VW
02 IS 300
04 Sienna
62 Cabriolet
56 VW
02 IS 300
04 Sienna