tunnel restoration 1959A

Message

tom collingwood · #1 Post by **tom collingwood** » Fri Feb 22, 2019 2:00 am

I am restoring the tunnel section of my 59A.

What goes inside it and where can i get it?

Dick Weiss · #2 Post by **Dick Weiss** » Fri Feb 22, 2019 11:27 am

Contact Stoddard, They have it available.

Jim Clement · #3 Post by **Jim Clement** » Fri Feb 22, 2019 11:56 am

there is lots going into / out of the tunnel..
here are a pic from each end.
from a 57 T1

Dan Macdonald · #4 Post by **Dan Macdonald** » Fri Feb 22, 2019 2:19 pm

Jim,
Do you have a similar photo(s) of the shifter and heater control knob areas for your '57 T1?

Jim Clement · #5 Post by **Jim Clement** » Fri Feb 22, 2019 5:09 pm

just these...
the heater control device affixes to the holes in the top of the tunnel..
what specifically are you looking for ??

Dan Macdonald · #6 Post by **Dan Macdonald** » Fri Feb 22, 2019 7:31 pm

thanks,
i'm replacing a "tower shifter" in my Speedster with an original shifter. Just want to make sure all the pieces are there and in the correct position when I'm done.

tom collingwood · #7 Post by **tom collingwood** » Sun Mar 24, 2019 10:26 am

Im getting ready to tackle the tunnel.
Any thoughts on fabricating this cover and what goes in it?

The Official 356Talk Forum

tunnel restoration 1959A

tunnel restoration 1959A

Re: tunnel restoration 1959A

Re: tunnel restoration 1959A

Re: tunnel restoration 1959A

Re: tunnel restoration 1959A

Re: tunnel restoration 1959A

Re: tunnel restoration 1959A