Length of 356C throttle pull rod

[M Penta]

I would like to buy a replacement throttle pull rod (the one that has the loop in it that attaches to pivot). I see there are 3 different lengths, and am too lazy to get under car to measure or remove it. Everything else in the throttle linkage has been replaced, and this rod looks a little crusty in the loop area and would hate to have it break. I think it is the 520mm but not certain, some say C's had two different lengths??

Thanks,

Mark

[Doug McDonnell]

520mm is correct: http://www.stoddard.com/69542301602.html

[M Penta]

Thanks Doug, will get one coming. Also replacing the plastic ball sockets on Weber linkage.

Mark