Page 1 of 1

Starter

Posted: Tue Jun 12, 2018 8:33 am
by EricMcKinley
I am placing my 912 motor into my 356C shortly.
I have a 200mm clutch pressure plate and disc I got from Rod Emory.
I also have a 200mm flywheel on the engine rather than the larger 912 flywheel, so good here.
The transmission is good, 741, rebuilt by Eric Wills.
The car is 12 volt.

Can anyone tell my what type of starter you think I would need.

Re: Starter

Posted: Tue Jun 12, 2018 12:46 pm
by David Jones
If the 200 mm flywheel is a 356 version then you can use the original starter motor but it would be advisable to change the solenoid to a 12 volt version otherwise you may mess up the teeth on the ring gear because of the extra force imparted to the starter dog by 12 volts being applied to a 6 volt solenoid.

Re: Starter

Posted: Tue Jun 12, 2018 1:09 pm
by EricMcKinley
Thanks for the reply David.

At present I have no starter motor, so im starting fresh in relation to this.

Re: Starter

Posted: Tue Jun 12, 2018 1:30 pm
by David Jones
In that case Eric you may want to consider this.
http://www.allzim.com/store/356-12v-1-0 ... ory_id=452

Re: Starter

Posted: Sat Jun 23, 2018 12:23 pm
by James Learmonth
Eric

I second Davids advice. I installed the 12volt geared starter from Zim's about a year ago. It fits perfectly. There is no bushing required. I have a stock 65C with 200mm. clutch and flywheel. You will be pleased with this product.

Jim Learmonth
Houston, TX