Does anyone have access to a stripped Pre-A tub??
I need to confirm a measurement.....
Center of rear torsion to center of front lower torsion
It will be either 1860 or 1855..
only 5mm but critical for Pre-A fixture development... Pre-A plans use a different Plan-O-line than ABC
Thanks in advance...
Cheers
Rich
Pre-A tub measurement
- Rich Ewald
- 356 Fan
- Posts: 26
- Joined: Thu Feb 17, 2011 2:56 pm
- Location: Columbia TN
- Contact:
- David Jones
- Classifieds Moderator
- Posts: 7323
- Joined: Tue Mar 25, 2008 6:32 pm
- Tag: I wish I knew as much as I think I know.
- Location: Kentucky
Re: Pre-A tub measurement
Where did I see that "C" coupe before? Oh yes, in a ditch in Kentucky.
If I had known I would live this long I would have pushed the envelope a little harder.
Cymru am byth
David Jones #9715
Cymru am byth
David Jones #9715
- Jim Liberty
- 356 Registry Member
- Posts: 4312
- Joined: Tue May 06, 2008 3:47 pm
- Tag: Jim
- Location: Orange Co., CA
- Contact:
Re: Pre-A tub measurement
I just sent my '55 off to Amelia. I will have an near original '54 here in my shop in a couple of weeks for a full restoration. Email me and I'll get you measurements for, - 51665. ...........Jim.
Jim Liberty
- Rich Ewald
- 356 Fan
- Posts: 26
- Joined: Thu Feb 17, 2011 2:56 pm
- Location: Columbia TN
- Contact:
Re: Pre-A tub measurement
THANKS Jim... Will doJim Liberty wrote:I just sent my '55 off to Amelia. I will have an near original '54 here in my shop in a couple of weeks for a full restoration. Email me and I'll get you measurements for, - 51665. ...........Jim.