Hey guys,
I have an early 1957 T1 coupe that I am currently restoring. A few pieces were missing including the rear garnish rails. I have sourced a set that came with some other parts but am not sure if they are correct for a T1 coupe. And unfortunately the body is currently at the restorers, so I am unable to see if they fit. I have notice that some of the rear garnish rails have a small cut out near the tab ( the ones I obtained have this cutout) and some remain flat without the cutout. I searched the forum prior to asking and have been looking around on the internet to no avail. While I saw some articles that referenced length( my rails are approximately 26.75 inches at the longest point without adding in the tab length), there seemed to be no reference to the cut out portion. Any and all advice is most welcome.
Thank you,
J
Rear Garnish Rail Question.....
-
- 356 Fan
- Posts: 74
- Joined: Tue Aug 15, 2017 9:30 pm
- Location: North Florida
-
- 356 Fan
- Posts: 1124
- Joined: Wed Apr 02, 2008 9:49 pm
- Location: Gilroy, CA
Re: Rear Garnish Rail Question.....
They look too correct, I think all As used the same pieces be it T1 or T2 body.
- Jim Clement
- 356 Fan
- Posts: 1471
- Joined: Tue Oct 26, 2010 10:46 am
- Tag: 1957 356 A Coupe
- Location: Calgary Alberta
Re: Rear Garnish Rail Question.....
I am trying to find a picture of mine..
they do look similar for sure.
one thing is that the tab should be at about 90 degrees .. not sort of bent straight, it fits under the rear upholstery piece.
they do look similar for sure.
one thing is that the tab should be at about 90 degrees .. not sort of bent straight, it fits under the rear upholstery piece.
- Jim Liberty
- 356 Registry Member
- Posts: 4320
- Joined: Tue May 06, 2008 3:47 pm
- Tag: Jim
- Location: Orange Co., CA
- Contact:
Re: Rear Garnish Rail Question.....
Jim, I always pushed mine straight in. Maybe 50 cars. Your approach is a better installation. ...........Jim.
Jim Liberty
-
- 356 Fan
- Posts: 74
- Joined: Tue Aug 15, 2017 9:30 pm
- Location: North Florida
Re: Rear Garnish Rail Question.....
Thank you guys. I was hoping these would be correct.
- Doug McDonnell
- 356 Fan
- Posts: 6081
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear Garnish Rail Question.....
The rear cutout has something to do with the rear defroster tube I think. Maybe a "C" thing? As they changed from a U shaped pipe to individual insulated pipes to the rear window?
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.