Hi All
Finally finished my 65 912 engine, and getting ready to install it in my 60 T5 B Cab. Changed the flywheel and other stuff recommended by the Maestro. But there is no discussion on throw out bearings. I have a 741 dual mount trans and a 200 mm 356 clutch flywheel assembly. . So, the question is which throw out bearing do I use ? B or C?
Thanks
Rich
throw out bearing
- David Jones
- Classifieds Moderator
- Posts: 7342
- Joined: Tue Mar 25, 2008 6:32 pm
- Tag: I wish I knew as much as I think I know.
- Location: Kentucky
Re: throw out bearing
Your TO bearing should ride on a short tube bolted to the transmission which shrouds the first motion shaft. Makes it item #9 in the Stoddard link here.
http://www.stoddard.com/porsche-356/por ... nents.html
Hence your clutch should be the 200mm one listed as item #4. That is what I deduce from the information you supplied.
Pictures would help to narrow it down.
http://www.stoddard.com/porsche-356/por ... nents.html
Hence your clutch should be the 200mm one listed as item #4. That is what I deduce from the information you supplied.
Pictures would help to narrow it down.
If I had known I would live this long I would have pushed the envelope a little harder.
Cymru am byth
David Jones #9715
Cymru am byth
David Jones #9715