Rear Wire Harness Routing Question
-
- 356 Fan
- Posts: 110
- Joined: Sat Dec 03, 2016 6:43 pm
- Location: Sacramento, Ca area
Rear Wire Harness Routing Question
Hello,
I bought this car disassembled and although the harness is intact, it was pulled away from its routing points and bundled. I'm working on the rear layout and can't determine where the upper harness enters the engine compartment. The apron around the perimeter of the engine compartment has been replaced with a new one if that matters. Once there, is it fastened using the metal tabs that run vertically and horizontally on the firewall? Can someone help?
Thank you,
Jack
I bought this car disassembled and although the harness is intact, it was pulled away from its routing points and bundled. I'm working on the rear layout and can't determine where the upper harness enters the engine compartment. The apron around the perimeter of the engine compartment has been replaced with a new one if that matters. Once there, is it fastened using the metal tabs that run vertically and horizontally on the firewall? Can someone help?
Thank you,
Jack
- Mike Wilson
- Classifieds Monitor
- Posts: 11636
- Joined: Tue Apr 15, 2008 4:37 pm
- Location: SW Los Angeles
Re: Rear Wire Harness Routing Question
As you are looking into the engine compartment, there should be a hole in the far right corner of the fire wall. Part of the harness goes up to the regulator, etc. and the other section snakes under the engine tin to the rear lights, etc.
Mike
Mike
Mike Wilson
Lomita, CA
'63 B coupe
Lomita, CA
'63 B coupe
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear Wire Harness Routing Question
If you engine perimeter metal was replaced there will be no hole. You will have to drill one. That is what I did, then found an appropriate sized grommet so that harness would not chafe where it went through.
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear Wire Harness Routing Question
This link will help some: viewtopic.php?f=4&t=43521&hilit=engine+ ... ent+wiring What year car? Be aware that you will end up with one spare black wire in the engine compartment when you are done. It is usually coiled on itself after entering the engine compartment viewtopic.php?f=1&t=35303&hilit=engine+ ... e&start=15
Last edited by Doug McDonnell on Sat Oct 14, 2017 8:21 am, edited 1 time in total.
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
- Mike Wilson
- Classifieds Monitor
- Posts: 11636
- Joined: Tue Apr 15, 2008 4:37 pm
- Location: SW Los Angeles
Re: Rear Wire Harness Routing Question
Good point, Doug. I missed that.
Mike
Mike
Mike Wilson
Lomita, CA
'63 B coupe
Lomita, CA
'63 B coupe
-
- 356 Fan
- Posts: 110
- Joined: Sat Dec 03, 2016 6:43 pm
- Location: Sacramento, Ca area
Re: Rear Wire Harness Routing Question
Thanks to both of you. You're both always so helpful and it is very much appreciated.
Jack
Jack
-
- 356 Fan
- Posts: 110
- Joined: Sat Dec 03, 2016 6:43 pm
- Location: Sacramento, Ca area
Re: Rear Wire Harness Routing Question
Car is a '63 coupe. Should have mentioned that.
Jack
Jack
- Eric McKinley
- 356 Fan
- Posts: 1348
- Joined: Sat Dec 21, 2013 12:09 pm
- Location: Belfast, Northern Ireland
Re: Rear Wire Harness Routing Question
Jack,
As Doug has mentioned you may need to drill that hole on the right corner as I did also.
Here are a few pictures I found a couple of years back that helped me understand it better.
As Doug has mentioned you may need to drill that hole on the right corner as I did also.
Here are a few pictures I found a couple of years back that helped me understand it better.
- Doug McDonnell
- 356 Fan
- Posts: 6084
- Joined: Sat Apr 05, 2008 8:21 am
- Location: Augusta,Michigan
Re: Rear Wire Harness Routing Question
Great photos Eric. They also show what happens to the rear wiring after engine compartment branches off. It continues to the rear a short distance, then goes through another hole to exterior where it wraps around the rear to taillights, reverse light etc.
1965 356C 2000 BMW 740i Sport 1967 Honda CL77 There is never enough time to do it right, but always enough time to do it over.
-
- 356 Fan
- Posts: 110
- Joined: Sat Dec 03, 2016 6:43 pm
- Location: Sacramento, Ca area
Re: Rear Wire Harness Routing Question
Eric,
Thank you very much for posting these very helpful photos. Just what I needed.
Jack
Thank you very much for posting these very helpful photos. Just what I needed.
Jack