356C Battery terminal clamp
Page 1 of 1

Author:  Hugo Karasawa [ Sat Jun 17, 2017 9:57 am ]
Post subject:  356C Battery terminal clamp

Where do you connect the red wire with the ring terminal ?
The 356 does not have a separate screw to connect this ring terminal.
The two small screws have conical seats and I think I should not use one of these screws for this terminal.

Battery terminal clamp 01.jpg
Battery terminal clamp 01.jpg [ 89.28 KiB | Viewed 430 times ]
Battery terminal clamp.jpg
Battery terminal clamp.jpg [ 48.58 KiB | Viewed 430 times ]

Author:  Jeffrey Leeds [ Sat Jun 17, 2017 10:27 am ]
Post subject:  Re: 356C Battery terminal clamp

It can be attached under the nut that tightens the clamp around the battery post. Make sure you clean the clamp very well. It doesn't look like it has been cleaned in a long time. And even more importantly, aggressively clean the negative clamp and ground strap at both ends.


Author:  Jon Schmid [ Sun Jun 18, 2017 1:00 pm ]
Post subject:  Re: 356C Battery terminal clamp

Just my $0.02 but I would just get a new clamp instead of trying to clean the pictured one.

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group