It is currently Mon Jun 18, 2018 12:51 pm

All times are UTC - 5 hours [ DST ]


Forum rules


Please click here to view the forum rules



Post new topic Reply to topic  [ 11 posts ] 
Author Message
 Post subject: '53 Transaxle Gear Noise
PostPosted: Thu Jun 07, 2018 5:39 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
Guessing this is normal for these old transmissions (to whine) from the year of 1953. But, told my friend that owns this car, would ask the Registry if this is normal. Think he has been listening to this noise for the past 40+ years... Also, this has a '59 engine in it.

Further, he complains of a hard time to get into reverse. I'm guessing the linkage probably needs to be adjusted.

What would be the test to determine if bearings/gears need to be replaced?

Thanks.


Attachments:
53 2.jpg
53 2.jpg [ 678.21 KiB | Viewed 276 times ]

_________________
Top
 Profile  
Reply with quote  
PostPosted: Thu Jun 07, 2018 8:53 pm 
356 Fan
User avatar

Joined: Mon Oct 23, 2017 9:51 am
Posts: 151
Location: Stanford, Ca. USA
Sounds perfectly normal to me.


Top
 Profile  
Reply with quote  
PostPosted: Fri Jun 08, 2018 12:27 am 
356 Fan
User avatar

Joined: Tue Jul 08, 2008 11:50 am
Posts: 616
Location: Whidbey Island WA.
Dan
Check the oil. Then.
You could jack it up on stands, remove the wheels and spin it by hand in neutral. Feel for dragging or small jerks, if it feels ok, hold one drum fixed, spin the other. Then start it and idle it in each gear and see if you hear anything.
It does not get driven much so it could have a couple light rusty or dry balls on a bearing.
Put it in 3rd or 4th and run it up to 2500-3000 for a few minutes. Just spin the axels and drums. Let the axels droop and they will fill the wheel bearings end with fresher oil. Get everything rotating and wetted.

If it does not make any unusually loud whining or noises, take it out and drive it fast in a low gear and try to sling some oil around and re wet everything.

_________________
John Brooks

62 Roadster
66 912
getting pushed around in porsches since 1965


Top
 Profile  
Reply with quote  
PostPosted: Fri Jun 08, 2018 11:03 am 
356 Fan
User avatar

Joined: Mon Dec 06, 2010 1:50 pm
Posts: 3280
Location: National City Ca
Hi
it probably would be prudent to have it torn down while there are a few "experts" practicing their craft.
j

_________________
 


Top
 Profile  
Reply with quote  
PostPosted: Fri Jun 08, 2018 5:27 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
John Lindstrom wrote:
Sounds perfectly normal to me.


Think you are right!

_________________


Top
 Profile  
Reply with quote  
PostPosted: Fri Jun 08, 2018 6:02 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
John Brooks wrote:
Dan
Check the oil. Then.
You could jack it up on stands, remove the wheels and spin it by hand in neutral. Feel for dragging or small jerks, if it feels ok, hold one drum fixed, spin the other. Then start it and idle it in each gear and see if you hear anything.
It does not get driven much so it could have a couple light rusty or dry balls on a bearing.
Put it in 3rd or 4th and run it up to 2500-3000 for a few minutes. Just spin the axels and drums. Let the axels droop and they will fill the wheel bearings end with fresher oil. Get everything rotating and wetted.

If it does not make any unusually loud whining or noises, take it out and drive it fast in a low gear and try to sling some oil around and re wet everything.


Drained the trans fluid last summer. Don't recall seeing anything that looked suspicious and don't think the plug was very bad at all with accumulated swarf. Pumped in gear oil off the shelf, not Swepco, don't remember what it was and was supplied by the owner. Have 201 in the shop, but perhaps 203 would be fine too which is straight 90w.

Once we get it in the air will do what you recommend and see what happens.

Thanks again for your post.


Attachments:
g356.jpg
g356.jpg [ 326.78 KiB | Viewed 165 times ]

_________________
Top
 Profile  
Reply with quote  
PostPosted: Fri Jun 08, 2018 6:04 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
Jacques Lefriant wrote:
Hi
it probably would be prudent to have it torn down while there are a few "experts" practicing their craft.
j


Will probably go down this road soon enough.

Thanks for posting here.

_________________


Top
 Profile  
Reply with quote  
PostPosted: Wed Jun 13, 2018 11:12 pm 
356 Fan
User avatar

Joined: Mon Oct 23, 2017 9:51 am
Posts: 151
Location: Stanford, Ca. USA
He probably needs to take it out and drive the piss out of it. Once she warms up a little, she’ll probably sing on the ride back to the garage. My cars always drive better once they’re warmed up real well.


Top
 Profile  
Reply with quote  
PostPosted: Thu Jun 14, 2018 12:11 pm 
356 Fan

Joined: Sat Jun 21, 2008 11:16 am
Posts: 1639
Location: Santa Monica, CA
Does it whine all the time? Under power, coasting, in every gear?

_________________
#6386


Top
 Profile  
Reply with quote  
PostPosted: Thu Jun 14, 2018 12:17 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
John Lindstrom wrote:
He probably needs to take it out and drive the piss out of it. Once she warms up a little, she’ll probably sing on the ride back to the garage. My cars always drive better once they’re warmed up real well.


Will bet the car has not seen a 50 mile drive in years. Only two people have driven this car under the current owner and I drove onto my lift and then off...... Think a spirited drive is certainly in order.

Thank you.

_________________


Top
 Profile  
Reply with quote  
PostPosted: Thu Jun 14, 2018 12:21 pm 
356 Fan
User avatar

Joined: Thu Mar 26, 2009 2:26 am
Posts: 520
Location: Pacific Northwest
Edwin Ek wrote:
Does it whine all the time? Under power, coasting, in every gear?


Not sure on this but will get to test drive once this “little” issue is resolved from a badly placed car and the garage door.....dang.


Attachments:
A8F14298-A831-4120-B5A3-9471A75DE389.jpeg
A8F14298-A831-4120-B5A3-9471A75DE389.jpeg [ 541.23 KiB | Viewed 46 times ]

_________________
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Baidu [Spider]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group