#11994 is in the reassembly phase -- bodywork done spectacularly well (no pictures, Mark doesn't see the point of joining and I haven't the energy to shrink my 10 meg images) as well it should be. I now realize that the 4 stud plate used on later cars is not used on my car -- rather the entire swing arm pivots on a single 6 mm hole through the left vertical panel at the front of the tunnel. I can not find either in the shop or parts manuals any description of what parts are involved. Please send description of needed parts (hopefully the swing arm is the same).
thanks
bill
Pre-A throttle swing arm
-
- 356 Fan
- Posts: 198
- Joined: Wed Mar 26, 2008 9:12 am
- Location: SE Michigan
- Vic Skirmants
- Registry Hall of Fame
- Posts: 9300
- Joined: Tue Oct 27, 2009 5:02 pm
- Location: SE Michigan
- Contact:
Re: Pre-A throttle swing arm
Bill; post this in Main Discussion. Nobody will see it here.
- Pete Archibald
- 356 Fan
- Posts: 124
- Joined: Tue Mar 25, 2008 5:49 pm
- Location: Hilton Head
Re: Pre-A throttle swing arm
Bill,
This is a better picture than the one I sent you last week. That's really all there is to it, except for the 65 mm bolt that acts as the pedal stop. It mounts in the hole that attaches to the right side of the brake/clutch pedal stop bar. I have an extra that I will send you.
This is a better picture than the one I sent you last week. That's really all there is to it, except for the 65 mm bolt that acts as the pedal stop. It mounts in the hole that attaches to the right side of the brake/clutch pedal stop bar. I have an extra that I will send you.