Pre-A throttle swing arm

356 Porsche-related discussions and questions.
Post Reply
Message
Author
Bill Block
356 Fan
Posts: 213
Joined: Wed Mar 26, 2008 9:12 am
Location: SE Michigan

Pre-A throttle swing arm

#1 Post by Bill Block » Fri Jan 31, 2014 1:50 pm

#11994 is in the reassembly phase -- bodywork done spectacularly well (no pictures, Mark doesn't see the point of joining and I haven't the energy to shrink my 10 meg images) as well it should be. I now realize that the 4 stud plate used on later cars is not used on my car -- rather the entire swing arm pivots on a single 6 mm hole through the left vertical panel at the front of the tunnel. I can not find either in the shop or parts manuals any description of what parts are involved. Please send description of needed parts (hopefully the swing arm is the same).
thanks
bill

User avatar
Vic Skirmants
356 Registry Member
Posts: 7066
Joined: Tue Oct 27, 2009 5:02 pm
Location: SE Michigan

Re: Pre-A throttle swing arm

#2 Post by Vic Skirmants » Fri Jan 31, 2014 10:47 pm

Bill; post this in Main Discussion. Nobody will see it here.

User avatar
Pete Archibald
356 Fan
Posts: 131
Joined: Tue Mar 25, 2008 5:49 pm
Location: Hilton Head

Re: Pre-A throttle swing arm

#3 Post by Pete Archibald » Sat Feb 01, 2014 1:34 am

Bill,

This is a better picture than the one I sent you last week. That's really all there is to it, except for the 65 mm bolt that acts as the pedal stop. It mounts in the hole that attaches to the right side of the brake/clutch pedal stop bar. I have an extra that I will send you.
Attachments
image.jpg
 

Post Reply