Petronix ignition

Message

Ken Daugherty · #1 Post by **Ken Daugherty** » Sun Jun 29, 2008 6:52 pm

I have a 050 distributor with an engine project. The distributor leads were disconnected from the coil and I would like to reconnect them properly so I can test the engine. There is a red lead and a black lead and the internal signal part of the distributor is marked 'Ignitor, Petronix'. What goes where?
I am a old fashioned kind of 356 guy and this new fangled stuff is new to me.

Ken Daugherty
kend356@insightbb.com

Post generated using Mail2Forum via email.

David Jones · #2 Post by **David Jones** » Sun Jun 29, 2008 9:29 pm

Ken;
The red goes on the hot side of the coil. Black instead of ground wire.

David

Joe Leoni · #3 Post by **Joe Leoni** » Mon Jun 30, 2008 10:12 am

Ken,
The red goes to #15 on the coil.
The black goes to the distributor, #1.
Joe
----- Original Message -----
From: "Ken Daugherty" <kend356@insightbb.com>
To: <356talk@356registry.com>
Sent: Sunday, June 29, 2008 4:54 PM
Subject: [356Talk] Petronix ignition

I have a 050 distributor with an engine project. The distributor leads were
disconnected from the coil and I would like to reconnect them properly so I
can test the engine. There is a red lead and a black lead and the internal
signal part of the distributor is marked 'Ignitor, Petronix'. What goes
where?
I am a old fashioned kind of 356 guy and this new fangled stuff is new to
me.

Ken Daugherty
kend356@insightbb.com

------------------------
Ken Daugherty

Post generated using Mail2Forum via email.