Help!
Someone please remind me what angle I set up the rear torsion bars on my SC using the transverse spring.
I want a put in a couple of degrees negative camber.
Is the dot on the torsion bar signigicant other than as reference?
THanks
Gene Choin
Oakhurst, CA 93644
Rear torsion orms setup
- Gene Choin
- 356 Fan
- Posts: 75
- Joined: Wed Apr 30, 2008 12:16 pm
Rear torsion orms setup
Eugene H Choin
Rear torsion orms setup
Some of the C's used a shorter bar when the compensator was used. The
length choices are 627 mm or 553 mm. You need to identify which one you
are using the diameter of the bar also. The only important marking on
the bar is L or R.
Alan
Gene Choin wrote:
length choices are 627 mm or 553 mm. You need to identify which one you
are using the diameter of the bar also. The only important marking on
the bar is L or R.
Alan
Gene Choin wrote:
Post generated using Mail2Forum via email.Help!
Someone please remind me what angle I set up the rear torsion bars on
my SC using the transverse spring.
I want a put in a couple of degrees negative camber.
Is the dot on the torsion bar signigicant other than as reference?
THanks
Gene Choin
Oakhurst, CA 93644
------------------------------------------------------------------------
Eugene H Choin
-------------------- m2f --------------------
To contact an administrator admin@356registry.com
<mailto:admin@356registry.com>
To unsubscribe go to http://www.356registry.com/forum/m2f_usercp.php
Read this topic online here:
http://356registry.com/forum/viewtopic.php?p=6079#6079
-------------------- m2f --------------------
- Gene Choin
- 356 Fan
- Posts: 75
- Joined: Wed Apr 30, 2008 12:16 pm
OK!
I have the shorter bars (554mm)
Does anyone know the setup angle for that bar?
I initiqlly set it for 20 degrees so I have a few degrees camber before I put on the compensator bar.
Gene
PS: Notice my avatar is the back end of the coupe with the great grease spot full of tools that has accumuated while I find the all answers following the brake rebuild!
I have the shorter bars (554mm)
Does anyone know the setup angle for that bar?
I initiqlly set it for 20 degrees so I have a few degrees camber before I put on the compensator bar.
Gene
PS: Notice my avatar is the back end of the coupe with the great grease spot full of tools that has accumuated while I find the all answers following the brake rebuild!
Eugene H Choin