Group (can I still say List?):
I'm reassembling a 64 Karmann Coupe. Having a dickens of a time fitting the chrome strips on the door tops - the holes in the strips just don't line up with the door holes any more. I think I've narrowed the problem down to the reproduction door top profile strips I bought from Stoddard (PN 644 531 951 00). They have a cross sectional profile something like
0-0
That is to say the inboard ridge has the same diameter as the outboard ridge.
Examining my original profiles, the inboard ridge has a significantly smaller diameter. I was able to fit the chrome strip to the door using the old profile with no problems; too bad, like so many other things in life, the old profile has shortened with age and can't be reused.
So does someone make a version of 644 531 951 00 that more closely corresponds to the original? Or should I methodically "shave" the profile? I really don't want to drill extra holes in my door if possible.
Any advice appreciated!
Charles
64 SC Coupe
65 C Coupe
Door Chrome Strip Profile Fitting Issue
- Charles Foster
- 356 Fan
- Posts: 225
- Joined: Tue Mar 25, 2008 10:55 pm
- Location: Los Angeles, CA
Door Chrome Strip Profile Fitting Issue
--
Charles Foster
http://www.northforkdesigns.net/porsche356/
Charles Foster
http://www.northforkdesigns.net/porsche356/
-
- 356 Fan
- Posts: 183
- Joined: Sat Apr 05, 2008 1:19 pm
- Location: NW Oregon
I just recently went thru this process myself. I found the best way for me was to simply drill some new holes as the furry strip which I replaced also was far thicker that the OEM part. This necessitated repositioning slightly downward to get enough clearance for the window to close or open. I did a full repaint so the old holes were well sealed so I didn't have any issues with future rusting. I then used #4 SS flathead screws (short!) to replace the old screws. My car is a 63 coupe and is intended to be a driver so I'm not concerned with concours stuff. Hope this helps. If I've confused you give me a call: 503-543-6750.
Ron Hoff
NW Oregon
NW Oregon
-
- 356 Fan
- Posts: 40
- Joined: Sun Mar 30, 2008 3:00 pm
I also just did mine in the last month and at first I had trouble but found the rubber bead I was using was a larger diameter "o" and was intended for the front hood chrome beading. After I found the correct pc all went well. The trouble I had was the same bead pc that fits under the vent window, it won;t get tight enough to stay put. I am using the original chrome pc that I had re chromed, I was told that the chrome pc was unavailable from Stoddards.
Larry
Larry