383 plug wires

[Cal Ensor]

Are the plug wires for the 383 distributor on a 3 piece case the same length for the later distributor ?
Any tips for piercing the wire insulation and installing in the distributor cap ?
Thanks
Cal

[Ken Daugherty]

Cal,
The wires may be the same length, cant say, but I make up my
own wire sets from a spool of Packard wire.
On the 383 caps, I use an ice pick to make a hole in the end of
the wire and then push it on the pins with a wood stick to assure they
are fully seated. If you don't do that it is possible to break the very
pricey cap.


Ken Daugherty
kend356@insightbb.com


-----Original Message-----
From: Cal Ensor [mailto:calsspeedster@webtv.net]
Sent: Tuesday, May 06, 2008 5:36 PM
To: 356talk@356registry.com
Subject: [356Talk] 383 plug wires


Are the plug wires for the 383 distributor on a 3 piece case the same
length for the later distributor ? Any tips for piercing the wire
insulation and installing in the distributor cap ? Thanks
Cal

------------------------
Cal Ensor Littleton,Co. Pre A
Speedster 80613




-------------------- m2f --------------------

To contact an administrator admin@356registry.com
To unsubscribe go to http://www.356registry.com/forum/m2f_usercp.php
Read this topic online here:
http://356registry.com/forum/viewtopic.php?p=4915#4915

-------------------- m2f --------------------

Post generated using Mail2Forum via email.